|
I chalked it up to
hardware when I read your message. Replace the
unit.
Ken
Should this have been reported as a bug??
One of the touchscreen ballot stations has a
significant "distortion" in the touchscreen calibration. I've used the
calibrate function and it works well on the top portion of the screen, but
does not seem to correct itself (I've tried this routine a dozen times or so
to see if I could figure out a pattern). The lower left corner has to
be hit about 1/2 inch above the mark (measured using the edge of a voter
card to be relatively sure about distance). The upper portion of the
screen is correct in its calibration. This makes it very difficult to
use the PREVIOUS function. Or to find many of the admin functions in
windows. Comments??
|