The Imation
disk drive is being assigned as the last IDE drive in the chain, by NT4.0, when
the 120 MB removable media is
installed;
Any other scenario causes the Imation to be the A
drive.
Using Kens, reverse logic, the Imation can be forced to
assume the drive D identifier in all cases as
follows:
Change bios
settings,
forcing Imation to always be the D
drive.
1) Category
"Standard CMOS Setup" Setting "Drive D
= NONE"
2) Category
"Standard CMOS Setup" Setting
"Drive A = 1.44,3.5 in."
3) Category
"Standard CMOS Setup" Setting "Drive
B = 1.44,3.5
in."
4) Category
"Standard CMOS Setup" Setting "Halt On
= ALL,BUT DISK/KEY"
5) Category
"BIOS Features Setup"
Setting "Swap Floppy Drive =
DISABLED"
6) Category
"BIOS Features Setup"
Setting "Boot Sequence = C
ONLY"
7) Category "BIOS Features
Setup" Setting
"Boot Up Floppy Seek = DISABLED"
Set Registry, Default Directory ,to look
for drive D.
8)
Start/Run/Regedit Category HKEY_LOCAL_MACHINE
/ SOFTWARE / Global Election Systems /
Accuvote-TS
Setting Def Dir =
D:/
Jeff Hallmark