|
The
symptom from the faulty printer power cable was that the printout would start
printing, but after a couple of lines it would quit printing. There was
never any error message on the screen from the operating system or application
software.
The
sequence of events for the original fault was the
following:
The
correction was to replace the connector on the transition board side of the
printer power cable. You can tell if it has been fixed if when viewing the
two wire cable, it is connected to the transition board with a white four pin
connector instead of reddish brown two pin connector. You'd have to remove
the front panel to view the transition board connections.
Ian
|